Design & Installation - Custom and Stock
PRODUCTS & SOLUTIONS
We design everything, from conception to installation – bearing requirements, block ratios determine whether it is single line, dual line, injector, line sizes, proper pump package (pneumatic, electric or hydraulic driven). For installation, we provide full turnkey installation or customer pick up and support. Our technicians are ready to help in any event.
We ensure that our international and domestic customers are not limited to just what they see in a catalogue. We design, configure and assemble for any need or requirement providing the flexibility our customers need for whichever application is being addressed.
We design everything, from conception to installation – bearing requirements, block ratios determine whether it is single line, dual line, injector, line sizes, proper pump package (pneumatic, electric or hydraulic driven). For installation, we provide full turnkey installation or customer pick up and support. Our technicians are ready to help in any event.
We ensure that our international and domestic customers are not limited to just what they see in a catalogue. We design, configure and assemble for any need or requirement providing the flexibility our customers need for whichever application is being addressed.
- Customer has a Mill with four bearing points. Needs an automatic system. We size the bearings and the lubrication requirements. We build and provide a pump and divider block with proximity switch and pneumatic or electric pump depending on need.
- Customer had bearing failure due to a very corrosive environment. We designed a stainless steel system, which enclosed in a stainless steel enclosure. All lines and fittings were designed to work effectively and efficiently in the hostile environment.
- Dredger – Environment was underwater. Company had copper lines with zerk fittings above the water which were manually greased to provide lubrication to the bearings which were underwater. The lines were copper which failed due to the environment. When we rebuilt the system we used stainless steel tubing, build a divider block system so they had only one point to lubricate all 10 bearings with a visual indicator showing that the system was cycling and performing as needed.
- Punch Press – Many older pump press systems used re-circulation oil systems which flood the bearings with the extra oil being caught in a basin funneling down into a reservoir. Given EPA regulations, the oil can’t just run down. We convert it to a terminating oil system using a divider block and metering pump to control the volume of oil. This results in the bearings getting exactly the amount of oil, typically .001 film thickness.
- Foreign & domestic customers requiring specialty gear box, oil level controls and heaters, all custom designed and assembled.